hole cut outs to accomodate larger tubes for X 10D

[alfred143]

I'm looking for some photos of x10D with holes cut out from the top of the cylinder to fit longer/Taller tubes.
also hints on how to make a clean cut.
Thanks all!

[Deleted]

I drilled holes in my X-Cans v.1 just after purchase. I used adhesive tape to precisely mark the right place to cut off. After that I used electric drill with reduction gear and speed selection. I drilled at low speed. I made a couple of holes along circumference in the inner part. After that on the later stage I used round file to connect small holes. It's very tedious work . Now I have a Dremel - high speed drill device (130W). I suppose it's much better to use this type of equipment with milling cutter.